InlineLoadCell.com — original / candidate replacement comparison worksheet
Owned engineering planning aid. Not a supplied sensor drawing or calibration record.

Original manufacturer / full item code / serial:
Original drawing identifier / revision / date:
Original range / tension-compression convention:
Original calibrated sensor + conditioner association:

                         ORIGINAL                 PROPOSED / VERIFIED
End A gender/thread/tolerance:
End A free/usable engagement:
End B gender/thread/tolerance:
End B free/usable engagement:
Shoulder-to-shoulder length:
Overall / maximum diameter:
Joint / wrench / cable clearance:
Working / transient / fatigue loads:
Stiffness / effective moving mass:
Excitation / bridge input resistance:
Rated sensitivity / zero balance:
Connector / mating view / key:
Excitation positive and negative:
Signal positive and negative:
Sense / shield / case / balance module:
Output scale / zero voltage / polarity:
Bandwidth / filter / latency / sample rate:
Temperature / ingress conditions:
Calibration points / reference / uncertainty:
Installed acceptance test / limits:

Open evidence and owner:
Approved candidate drawing / revision:
Engineering sign-off / date:

Send the original reference packet and load case to inquiry@inlineloadcell.com.