MT-ILC-MM / 50 N–20 kN
Male-to-Male Stud Inline Load Cell
A male-to-male stud inline load cell fits a threaded linkage where two female mating parts must connect through a force transducer.
Request drawing & quotation ↗Hydraulic rods · pneumatic systems · test linkages
Connect axial sensing through two external studs.
Specify thread root loading, tightening method and transient peaks. Do not transmit installation torque through the sensing section or use an ultimate overload value as a working rating.
Three inputs for the first drawing review
- Stud diameter, pitch, free length and shoulder geometry
- Shock peaks, fatigue cycles and installation torque
- Temperature, ingress and connector requirements
Family selection ranges follow the project catalog plan. Dimensions, accuracy, material and IP rating are confirmed for the quoted part.
PART NUMBER BUILDER
Configure a reference for the engineering review.
Select a capacity, thread and output to carry into the request below. Mixed threads require both ends in the RFQ. This reference is subject to drawing approval.
ENGINEERING RFQ / SAMPLE REQUEST
Send the load case.
Define the interfaces.
Include both thread ends, working and peak force, available space and the signal your controller expects.
Company and university email domains are preferred. Prototype and research inquiries are welcome.
inquiry@inlineloadcell.com ↗